Frequency coverage:
|
amateur bands 1.8 – 29.7 MHz including WARC
|
Power output:
|
2500 W in SSB and CW
2000 W in RTTY, AM and FM
|
Driver Power:
|
60 to 80 W for full Output Power
|
Input impedance:
|
50 Ohm VSWR < 1.5 : 1
|
Output amplification:
|
17 dB
|
Output impedance:
|
50 Ohm unbalanced
|
Maximum output SWR:
|
2:1
|
SWR protection:
|
automatic switching to STBY , when reflected power is 350W or higher
|
Intermodulation distortion:
|
32 dB below nominal output
|
Suppression of harmonics:
|
< -50 dBc
|
Tube:
|
GU84b Ceramic tetrode
|
Cooler:
|
Centrifugal blower + axial blower
|
Power supply:
|
2 x 230 V - 50 Hz one or two phases
|
Transformers:
|
2 pcs of toroidal transformer 2.0 kVA
|
Protection circuits:
|
- SWR too high
|
|
- Anode current too high
|
|
- Screen current too high
|
|
- Grid current too high
|
|
- Mistuning of power amplifier
|
|
- Soft start for protecting your fuses
|
|
- “switch –on blocking “ at opened amplifier
|
Bar graph indications:
|
- Power output – bargraph 50 LED
|
|
- Reflected power – bargraph 20 LED
|
|
- Current at screen ( Ig2 – bar graph 10 LED )
|
|
- Anode voltage, anode current, tuning – bargraph 30 LED
|
LED indicators:
|
- current at control grid ( Ig1 – 2 LED )
|
|
- WAIT – preheating of tube (180 sec )
|
|
- STBY– standby
|
|
- OPR – operating condition
|
|
- FAULT – failure, switching off for abt. 4 sec
|
|
- Inhibit – operating condition
|
|
- ANT 1 - which ANT is use
|
|
- ANT 2 – which ANT is use
|
|
- UP – DWN - listing in menu
|
|
- MAN - manual operating
|
|
- AUTO - automatic operating
|
|
- TUNE - tuning
|
|
- ANT - ANT selection
|
Parameters:
|
485 x 200 x 455mm (width x height x depth)
|
Weight:
|
40 kg
|
